To Use Stain Remover is a blend of natural earth and other ingredients
designed to remove oil, grease and tannin stains. It has a pudding-like
consistency that makes it very easy to spread, with no mixing required. It can be covered, or left uncovered overnight and up to 72 hours to dry.
- • Oil & grease stain remover
• Works on concrete and porous stone materials
• No mixing required
• ready to use & easy to spread
How to use::
INSTRUCTIONS: Clean surface of stone with Easy Oxy to remove any surface debris or
residue. Place Stain Remover over affected area and build up
approximately 1/4" high and overlap edges of stain by 1/4"-1/2". Place
plastic wrap over the stain and press down lightly to retard drying
time. If it a warm or dry climate, seal edges of plastic with masking
tape to prevent Stain Remover from drying too quickly. The solution will
dry into a hard crust. Simply scrape the crust off the counter into a
trash can and clean any remaining residue with Easy Oxy. Allow to dry
for a couple hours, or dry with a hair dryer for 15 minutes or so.
Inspect the area to see if it has improved. If the stain is completely
gone, you are done. If the stain is partially removed, repeat the
process until gone.
TIP: Take a picture of the area before starting the process.
After removing the Stain Remover, and drying the area, take another
picture. Pictures make it much easier to see stains and how they change
than it is to see in person.
Ensure proper ventilation when using this product.