Home > For The Fabricator >

NEW - Omni Cubed Miter-It™ Auto - NEW
Miter-It Auto

Alternative Views:

The Miter-It™ Auto is an easy-to-use clamp featuring proprietary vacuum cup system with ultimate holding power. Use minimal shop (compressed) air to power the 1/2 CFM venturi vacuum generator, which accommodates up to ten clamps simultaneously (Starter Kit includes two clamps; additional clamps can be purchased separately). This system allows finished-side-up miter laminations; not flipping the material offers numerous benefits including increased safety for workers, reduced risk of damage to the material, and keeping the seam in view during lamination. The Miter-It™ Auto securely holds heavy drop-down edges at 90°, eliminating the need for a helper to position the material, and also enables vertical and horizontal fine-tune adjustments. This simple, yet innovative tool greatly reduces the numerous awkward adjustments required with other miter clamps, offers extremely strong and reliable hold, and offers better results than taping methods alone. Accommodates edges up to 12"

Starter Kit includes two clamps, 10-port Venturi Vacuum Generator and storage case.

Item# Item Name List Price Qty Add
VG-10 Miter-It™ Auto Venturi Vacuum Generator - PRE-ORDER: Ships Mid-June
MTR-153 Omni Cubed Miter-It™ Auto Clamp - PRE-ORDER: Ships Mid-June
MTR-153K Omni Cubed Miter-It™ Auto Starter Kit - PRE-ORDER: Ships Mid-June
Check the items you wish to purchase, then click

    • Miter pieces with finished side up; keep your eye on the seam
    • No flipping for gluing; save your back and protect material from breakage
    • Holds miter piece for you; eliminates need for a helper
    • Automatically squares the miter; no complex, awkward adjustments; saves time
    • Increases efficiency of lamination taping methods
    • Fast, simple adjustments to get the piece in place and the seam tight
    • Multi-port vacuum generator accommodates up to 10 clamps at the same time
    • Coarse and fine-tune adjustments for exact and tight seams
    • Reliable hold; 1/2 CFM vacuum source
    • Proprietary non-marking suction cups
    • Accommodates laminated edges up to 12 inches tall

How to use::
Typically one Miter-It™ Auto clamp every 3-4 feet is sufficient, but more may be used for extra-long or heavy aprons. Attach up to eight additional clamps to the single vacuum generator included in your starter kit. Wherever you would need a hand to hold the material, put a Miter-It™ Auto clamp there instaead.

Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

For The Fabricator
Omni Cubed > Miter-It™ Clamps
Omni Cubed